Author Topic: Wind Turbine work.  (Read 2175 times)

0 Members and 1 Guest are viewing this topic.

Eraser3000

  • Newbie
  • *
  • Posts: 36
  • Country: us
Wind Turbine work.
« on: October 10, 2016, 11:55:05 PM »
I had to replace my wind vane.

Its a 4-20ma unit.

10016-0
Cover.
10017-1
A picture inside.

Done.
10019-3

Bruce S

  • Administrator
  • Super Hero Member Plus
  • *****
  • Posts: 5370
  • Country: us
  • USA
Re: Wind Turbine work.
« Reply #1 on: October 11, 2016, 09:03:18 AM »
I'm enjoying the blue skies and great pics of the Earth!
A kind word often goes unsaid BUT never goes unheard

Eraser3000

  • Newbie
  • *
  • Posts: 36
  • Country: us
Re: Wind Turbine work.
« Reply #2 on: October 11, 2016, 11:05:58 AM »
Thanks Bruce, I enjoy being up in the air with the view.
Eraser

SparWeb

  • Global Moderator
  • Super Hero Member Plus
  • *****
  • Posts: 5452
  • Country: ca
    • Wind Turbine Project Field Notes
Re: Wind Turbine work.
« Reply #3 on: October 12, 2016, 10:43:36 PM »
Good work.
My anemometer needed replacement this summer, too.
Hailstone snapped one of the cups clean off.

I guess you're pretty comfortable up a heights, to do that job!
No one believes the theory except the one who developed it. Everyone believes the experiment except the one who ran it.
System spec: 135w BP multicrystalline panels, Xantrex C40, DIY 10ft (3m) diameter wind turbine, Tri-Star TS60, 800AH x 24V AGM Battery, Xantrex SW4024
www.sparweb.ca

frackers

  • Sr. Member
  • ****
  • Posts: 435
  • Country: nz
  • Picard spits "Hello"
Re: Wind Turbine work.
« Reply #4 on: October 13, 2016, 05:50:47 AM »
I guess you're pretty comfortable up a heights, to do that job!

Makes my toes curl up just looking!! Not very good with heights...
Robin Down Under (Or Are You Up Over)