« previous next »
Pages: [1]   Go Down

Author Topic: Gen Off-Set from Tower,  (Read 977 times)

0 Members and 1 Guest are viewing this topic.

coldspot

  • Hero Member
  • *****
  • Posts: 843
  • Country: us
Gen Off-Set from Tower,
« on: June 16, 2006, 01:31:23 AM »
"if you make the alternator offset less than about 4% of rotor diameter it will never furl"

That sounds like good info

So if it is then

How much offset for say a 8'

Or how about a 10'

????????????????????????????????
« Last Edit: June 16, 2006, 01:31:23 AM by (unknown) »
Logged
$0.02

Countryboy

  • Sr. Member
  • ****
  • Posts: 269
Re: Gen Off-Set from Tower,
« Reply #1 on: June 15, 2006, 07:57:50 PM »


  1. % of 8 feet is an offset of 3.84 inches away from the yaw bearing.
  2. % of 10 feet is 4.8 inches.


Or, you can just use the rule of thumb, 1/2 inch of offset for each foot of rotor diameter.
« Last Edit: June 15, 2006, 07:57:50 PM by Countryboy »
Logged

coldspot

  • Hero Member
  • *****
  • Posts: 843
  • Country: us
Re: Gen Off-Set from Tower,
« Reply #2 on: July 26, 2006, 05:13:23 PM »
Countryboy-

After reading this site for a year or so,

I missed that one?  :(

lol


THANK YOU

« Last Edit: July 26, 2006, 05:13:23 PM by coldspot »
Logged
$0.02
Pages: [1]   Go Up
« previous next »