I played with stepping Sonceboz Unipolar Hybird with LED
(thanks ghurd). the light was up when my fingures spun.
I made 18"x18" Ed verticle blade (thanks windstuffnow).
I counted 60 rpm with low speed fan home appliance.
So I put gear (ratio 1:3) and thought rpm would be more
then 150 rpm. But nothing's happened.
Did I do somthing wrong? (Cogging??)
...And
Go for shopping...I got a 71mm 12 tooth stator, it came out
of a copier, it is brushless servo motor with a gear box
without board. The original specs are 30V DC 367rpm.
The small motor is 27mm thick and it has 4 Mags in the can.
3 wires of servo and 6 wires for encoder.
Pictures...
http://www.otherpower.com/images/scimages/6442/DCinside.jpg
http://www.otherpower.com/images/scimages/6442/DCinside2.jpg
Could you please give me advice or any linkage for brushless servo genni, I'd appriciated.
Thank you very much
I did search before asking.
but...I am blind in reading.
pictures are more than 1,000words.
