« previous next »
Pages: [1]   Go Down

Author Topic: Stacker update  (Read 930 times)

0 Members and 1 Guest are viewing this topic.

tecker

  • SuperHero Member
  • ******
  • Posts: 2183
Stacker update
« on: February 17, 2007, 10:42:25 PM »
I got around to adding a third coil  to the  jig  .I offset the coils by 3 and 6 degrees .Looks like there's a slight difference in the width of the rise from zero ( stacked in line series ) . Am  finishing  out the stator at three degrees center coil and 6 degree outside sacrificing some peck to peck voltage for duration  . Pdf links for 0,3,6,7, degrees .





http://www.otherpower.com/images/scimages/1431/0de_2v.pdf

http://www.otherpower.com/images/scimages/1431/3de_2v.pdf

http://www.otherpower.com/images/scimages/1431/6de_2v.pdf

http://www.otherpower.com/images/scimages/1431/7de_2v.pdf

« Last Edit: February 17, 2007, 10:42:25 PM by (unknown) »
Logged

Nando

  • Hero Member
  • *****
  • Posts: 1058
Re: Stacker update
« Reply #1 on: February 17, 2007, 08:45:09 PM »
Tecker:


Can you detail the software you use for the measurements that you have displayed on the PC.


Thanks


Nando

« Last Edit: February 17, 2007, 08:45:09 PM by Nando »
Logged

tecker

  • SuperHero Member
  • ******
  • Posts: 2183
Re: Stacker update
« Reply #2 on: February 17, 2007, 09:52:44 PM »
 Tip 440 scope meter software version 4.43
« Last Edit: February 17, 2007, 09:52:44 PM by tecker »
Logged

tecker

  • SuperHero Member
  • ******
  • Posts: 2183
Re: Stacker update
« Reply #3 on: February 18, 2007, 10:21:24 AM »
 The measurements were made on three 25 turn coils offset in series.Somewhat simular to

a single coil with wide legs at 75 turns. Mags are 1/2 X 1.5 x 1/2
« Last Edit: February 18, 2007, 10:21:24 AM by tecker »
Logged
Pages: [1]   Go Up
« previous next »