Yes it's a tiny mill,18" blades the rotor is a touch under 5 inches , 16 mags single rotor. magnets are 1/2" round 1/2" thick neo's.
I had thought about using the 17 gauge & running a 120 to 12 volt wall transformer backwards but I may just get some fine wire.
I am hoping to wire some D or C cells in series to get 12 volts & run a zener diode to activate a small dump load. the 12volt battery will run a small 12 volt car lighter inverter & then a 10 watt bulb(maybe).
Not sure if a mill that small with those tiny mags will make that much juice but I'll find out,if not I'll go with led's or something...
Devin