« previous next »
Pages: [1]   Go Down

Author Topic: Bushing swapout  (Read 1462 times)

0 Members and 1 Guest are viewing this topic.

tecker

  • SuperHero Member
  • ******
  • Posts: 2183
Bushing swapout
« on: March 15, 2008, 11:19:33 AM »
I' ve created some space to rebuild some cores . These end caps are pretty standard in fan motors . I coped out the mount and packing for the bushings and inset some 1 1/4 tubing . With some allen keys is a good fit .







« Last Edit: March 15, 2008, 11:19:33 AM by (unknown) »
Logged

TheCasualTraveler

  • Sr. Member
  • ****
  • Posts: 404
Re: Bushing swapout
« Reply #1 on: March 15, 2008, 06:10:51 AM »
     I use pvc for holding bearings also. I found a 1" to one and 1/4" bushing from ACE hardware fits a standard size bearing perfect and tight (no set screws). Check out my page for pictures. In the middle of the first picture there are two bushings in the center, 1 facing up and one facing down. The one on the right shows the indentation where a bearing fits but only on the ones from ACE.

http://www.thecasualtraveler.com/my_next_windmill.htm
« Last Edit: March 15, 2008, 06:10:51 AM by TheCasualTraveler »
Logged

tecker

  • SuperHero Member
  • ******
  • Posts: 2183
Re: Bushing swapout
« Reply #2 on: March 15, 2008, 07:01:49 AM »
 Nice That's an easy add .How is the pvc holding up?
« Last Edit: March 15, 2008, 07:01:49 AM by tecker »
Logged

TheCasualTraveler

  • Sr. Member
  • ****
  • Posts: 404
Re: Bushing swapout
« Reply #3 on: March 15, 2008, 07:39:24 AM »
PVC is holding up fine. Being out in the sun I painted it white to block UV.
« Last Edit: March 15, 2008, 07:39:24 AM by TheCasualTraveler »
Logged
Pages: [1]   Go Up
« previous next »