« previous next »
Pages: [1]   Go Down

Author Topic: motor conversion blades  (Read 1315 times)

0 Members and 1 Guest are viewing this topic.

kattos

  • Newbie
  • *
  • Posts: 45
motor conversion blades
« on: October 01, 2009, 09:05:12 PM »
this is my last motor conversion 1 hp 4-6 ampsx12volts
« Last Edit: October 01, 2009, 09:05:12 PM by (unknown) »
Logged

wpowokal

  • Hero Member
  • *****
  • Posts: 1271
  • Country: au
  • Far North Queensland (FNQ) Australia
Re: motor conversion blades
« Reply #1 on: October 01, 2009, 10:24:15 PM »
My crystal ball is down for repairs!


allan down under

« Last Edit: October 01, 2009, 10:24:15 PM by wpowokal »
Logged
A gentleman is man who can disagree without being disagreeable.

hiker

  • Hero Member
  • *****
  • Posts: 1661
  • BIG DOG
Re: motor conversion blades
« Reply #2 on: October 01, 2009, 10:45:18 PM »
my crystal ball says this is it............

blades look fine!!

   http://www.fieldlines.com/images/scimages/11257/wind_043.jpg


might be a shorted coil???--miss wired?? have you checked your coils

and wiring???????

« Last Edit: October 01, 2009, 10:45:18 PM by hiker »
Logged
WILD in ALASKA

wpowokal

  • Hero Member
  • *****
  • Posts: 1271
  • Country: au
  • Far North Queensland (FNQ) Australia
Re: motor conversion blades
« Reply #3 on: October 02, 2009, 05:18:59 AM »
Still broken, I see a good set of blades a cordless drill and charger etc.........


guess I am just thick, unable to see the obvious.


allan down under

« Last Edit: October 02, 2009, 05:18:59 AM by wpowokal »
Logged
A gentleman is man who can disagree without being disagreeable.

Jerry

  • Hero Member
  • *****
  • Posts: 1519
Re: motor conversion blades
« Reply #4 on: October 02, 2009, 07:39:32 AM »
Allan I see the same thing you see. Hard to figure out the genny problems when all you see is the blades and very littel info on the rest of the system.


This is ment in good humor but its kinda like saying.


Hey DOC I don't  feel good whats wrong with me?  LOL.


Need more motor specs,  like HP, single or 3 phase, rpm, motor voltage, pole count,


and coil or phase reconfigurations, magnet type ( ceramic or NEO), magnet shape, magnet count, scewed , not scewed, PMA operating voltage, ect, ect ?


I think then we could sort some things out.


                  Jerry

« Last Edit: October 02, 2009, 07:39:32 AM by Jerry »
Logged

wpowokal

  • Hero Member
  • *****
  • Posts: 1271
  • Country: au
  • Far North Queensland (FNQ) Australia
Re: motor conversion blades
« Reply #5 on: October 02, 2009, 04:42:53 PM »
There are pics in his files but which one is it they all look good, anyway he can't be serious his work bench is too clean, I'm jealous.


allan down under

« Last Edit: October 02, 2009, 04:42:53 PM by wpowokal »
Logged
A gentleman is man who can disagree without being disagreeable.
Pages: [1]   Go Up
« previous next »