Hi all,
A question that I am sure has probably been asked a thousand times but I could not find the desired answer having "googled" the board.
Are the Ametek 30v dc motors really any good for a decent amount of power or are there now better alternatives available? I have one that I am messing about with but am very undecided. I reckon 350rpm is about what one would want but I really want something to start up lower than this to make the most of available wind.
I cheated somewhat with my other mill and managed to get a used but perfectly adequate "Windblue" motor at a greatly knocked down price and to be honest am wondering whether to hold out to find another of these and sell the Ametek, as I am not in such a rush to try to put a system together this time. Not going back out on location until April 09.
Thanks again all, any input would be most welcome.
