OK... I made a 3.5"x3.5" coil out of 24 awg (NEW) with 10 turns. I cleaned the ends of the coil, made the connections to the meter, checked for continuity, set meter for 10VAC, inserted the rotor thru the end of the coil so that the shaft runs parallel with the coil. I put four of the 1/2"sq x 2" on the old rotor shaft at 12,3,6,9 oclock alternating N S N S. the top and bottom of the coil will get both North poles first, then as the rotor turns 90 degrees, the coil gets the south poles. No volts... Did I use too few turns? or is the magnet setup wrong? That link to the Faraday site looks like the coil needs to see north at top and south on bottom at the same time. Is that right?