« previous next »
Pages: [1]   Go Down

Author Topic: re winding configuration  (Read 842 times)

0 Members and 1 Guest are viewing this topic.

johnyb

  • Newbie
  • *
  • Posts: 29
re winding configuration
« on: February 13, 2009, 08:01:01 PM »
this is a newbie ? steven fahey posted some time back winding configuration very nice job being newbie elecricly ilitterate:} i see coils numbered 1,2,3 on the build a 10 ft windmill post on this under build stator and staor windings wired in star which is y coils numbered 1,2,3 my question is how do i number coil wires 1 thru 12 to be able to wire stator jerry configuration thanks in advance


dumb newbie

« Last Edit: February 13, 2009, 08:01:01 PM by (unknown) »
Logged

electronbaby

  • Sr. Member
  • ****
  • Posts: 407
  • Country: us
    • Windsine.org
Re: re winding configuration
« Reply #1 on: February 13, 2009, 02:46:48 PM »
If you will wire Jerry:


Each coil OR discrete group of coils will have its own rectifier.

« Last Edit: February 13, 2009, 02:46:48 PM by electronbaby »
Logged
Have Fun!!!  RoyR KB2UHF

Flux

  • Super Hero Member Plus
  • *******
  • Posts: 6275
Re: re winding configuration
« Reply #2 on: February 13, 2009, 04:06:28 PM »
If you rectify each coil then no need to worry about connecting as long as both ends of a coil go to its rectifier.


If you Jerry connect each phase rather than each coil just wire the phase coils in series as if it was star but connect the start and finish of each phase to its rectifier.

Flux

« Last Edit: February 13, 2009, 04:06:28 PM by Flux »
Logged
Pages: [1]   Go Up
« previous next »