I can not find this anywhere.... where did you get your bearing hub for your generator?

[d3lilley]

I've wasted a lot of time searching for the bearing hub I need, and I still can't find it. Where did you purchase/find your bearing hub that you used for your permanent magnet alternator? The directions I am following call for a specific design. Here is the design: (I apologize for the size)

Thanks

Did a one time fix of your over width photo.  TW

[CmeBREW]

Perhaps you can call this Company and ask specific questions on spacing or adjust a few things:

http://www.northerntool.com/webapp/wcs/stores/servlet/NTESearch?storeId=6970&N=0&Ntk=All&
;Ntt=hub&Nty=1&D=hub&Ntx=mode+matchallpartial&Dx=mode+matchallpartial

[freejuice]

Hi,

 I didnt quite follow things to a "T" I went to a Northern tool store about 9 miles from here and bought the closest thing I could find, and afte a little modification with the ol' welder it works ok, however I did mount the face of my trailer hub to the BACK of my rotor...not to the inside. While I'm lucky enough to have a lathe  to turn it down  I elecetd not to do that....thus I didnt have to drill a large hole in my blades/hub to clear the bearing cap.

Only time will tell how it will perform....click on my screen anme and click file you can see the mill setup the way I just described it )

 All the best,

 Gavin

[kurt]

http://www.etrailer.com/p-34822BX/Trailer-Hub-Assembly---2000-lbs-Axles---4-on-4.html

that is the hub the dan's use on there 10' mills like here on the site and in there book don't know if that helps any??

[Tritium]

Here is another link for you:

http://www.trailerpart.com/

Thurmond

[d3lilley]

Thank you that's probably the closest I've come to what I need so far. Thanks for the help!