« previous next »
Pages: [1]   Go Down

Author Topic: I need some help  (Read 1178 times)

0 Members and 1 Guest are viewing this topic.

icicle

  • Jr. Member
  • **
  • Posts: 62
I need some help
« on: September 20, 2006, 07:43:31 PM »
I know most of you have more insight than I, I am still confused on how to make a 24 volt dc gennie. I've been reading the post for a while and did some searches for single phase and haven't found what I want yet. Could you folks please help me out

« Last Edit: September 20, 2006, 07:43:31 PM by (unknown) »
Logged

AbyssUnderground

  • Sr. Member
  • ****
  • Posts: 461
Re: I need some help
« Reply #1 on: September 20, 2006, 01:53:58 PM »
If you are still confused then you should keep reading, or ask a question on what you are having problems understanding on the subject. We can only help if you give us the question to help you with :-)
« Last Edit: September 20, 2006, 01:53:58 PM by AbyssUnderground »
Logged

Titantornado

  • Sr. Member
  • ****
  • Posts: 290
  • Country: us
Re: I need some help
« Reply #2 on: September 20, 2006, 02:28:19 PM »
Well, to start, I don't think you want single phase for wind.  Go for three phase. (it's easier than it seems)


Are you thinking axial flux or motor conversion?

« Last Edit: September 20, 2006, 02:28:19 PM by Titantornado »
Logged

icicle

  • Jr. Member
  • **
  • Posts: 62
Re: I need some help
« Reply #3 on: September 21, 2006, 10:43:50 AM »
how do I wind the coils for 24 volt, Do I need to wrap one CW and the other CCW.?
« Last Edit: September 21, 2006, 10:43:50 AM by icicle »
Logged
Pages: [1]   Go Up
« previous next »