Hello all, I have decided to build a couple of 10'ers and will probably have quite a few questions on the way. I have to reread the instructions a lot, probably most of these answers are somewhere in front of me, but I may be having trouble finding it. Any ways, gonna go with the 1"x2"X1/2" blocks, 14 awg 2 in hand, and about to make the coil winder. What I needed to know was the dimensions of the pin placement for the I.D. of the coil, from the outside of the pins, both top, bottom, and from top to bottom. Now also, I think I also seen someone winding a coil with 14 awg, 2 in hand, 37 wraps for lower cut in, just adding an additional wrap. Is there a post regarding what the performance change might expected that I can reread regarding this deviation. Any other advise before I get started building is welcome. Thank you, Joe