I am in the hard ware assembly stage of making a tracker, I have a 90 degree worm drive off one of those disability scooters, very powerful motor, but where I seem to be unable to pick a method of connecting it, and then how to do the final thrust berring for the azimuth support.
So can we get some pics of how you did the berring system for the mast rotor?
I am thinking chain will be the easiest way to couple the motor to the main suport shaft, and welding say 10 bike sprockets back to back will over some major safety factor and more then enough strength to handle any winds that get thrown at it
For the thrust berring one thought was use an old wheel hub but I am cuatious about that as it will be holding a few $k in panel! so I need to see some images of how others have don it to draw some conclusions!
Thanks in advance! will post detailed pics of this project when don!