Well, December in the PNW was another month of heavy rain with the river reaching absolutely bank full. January has now started off with about 16 inches of snow followed by rain. I won't be working near the river for a while.
I've been doing some other projects in the meantime, but now have the the following items underway:
-Purchased two SKF spherical roller bearings and pillow blocks for the water wheel. For a 70mm shaft they are very pricey. I coated the pillow blocks with POR 15 so they won't eventually rust.
-Purchased 7.5kw PM generator. Now complete and being shipped from China as I write this.
-Fabricated 5 foot diameter drive sheave for water wheel to drive the generator. Final machining underway.
-Purchased sched 40 12" diameter x 20' long pipe for the cantilever as well as two 4"x 6" x 7 feet square tubing to hold the water wheel which will be welded to the pipe. I'll start fabricating that once I clean up the garage.
-Came up with a more sophisticated and better design for the stand to support the cantilever. It will be cast right into the concrete foundation instead of being anchored to the surface. Have purchased the materials for that and will start fabbing that as well
This is taking longer than expected, but then again all my projects seem to do that
![Smiley :)](https://www.fieldlines.com/Smileys/default/smiley.gif)