Miscellaneous > Fabrication

Cad model?

<< < (5/5)

MattM:
Virtual machines are easier than scavenging hardware.

You might try one.  Reports of being slow are exaggerated.

JW:
Im doing good with my CAD software "overall"  I was hoping to get the SW 2000 up by now, I had it there for a day or two. One problem the aspect ratio was off vertical to horizontal. Im not sure if this an inherent problem running SW 2000 on XP or from the graphics card. I was using VGA but want to try it with HDMI. Nevertheless I now need the dell drivers be cause I cant get it to pickup the hard drive. Im very lucky to have my office hardware up running I couldn't write checks and make printed estimates. (there two separate programs)


Ok here's one to the spirit of the fabrication section  ;D




Here's the graphics card




Room and monitors-





Im running a tube amp with Klipsch KLF 30 rocking out. I'm lucky I can jam my system all night and no one hears it  ;D


Heres my stuff with SW 2016 fully operational  ;D







I had a problem running the SW on XP the aspect ratio was off, using VGA I want to try HDMI to see if it fixes that.

 

Navigation

[0] Message Index

[*] Previous page