View full version: Newbies
  1. MOVED: Curtis PMC 1208 2312 not responding.
  2. beginner project
  3. Ed Lenzs' microwave generator
  4. Used Xantrex 4024 ....safe to buy used?
  5. why make ac then change to dc
  6. Barrel Darrieus suggestions wanted
  7. magnet cutting, drilling
  8. Emf?????
  9. Too much wind automatic slow down
  10. How to build and assemble my own stator ring
  11. Inductance Question
  12. Axial Flux theory questions
  13. holes in coils waste space?
  14. Long Term Charging?
  15. just starting out a little help please ..
  16. 17 Foot Offset & Forward Offset
  17. voltage
  18. 24v or 48v
  19. Best grease for battery connections?
  20. ANTI MAGNETIC MATERIALS
  21. RAISING THE EFFICIENCY OF SOLAR PANELS
  22. RADIOMETERS
  23. 17 foot stator (personal observations)
  24. low Amp output
  25. MOVED: Hello from Turkey
  26. Small Axial Flux Alternator (Hand Crank)
  27. Can you.....
  28. Steel Disks
  29. Podercoating vs. Zinc rich rustproof paint
  30. Introduction, DIY charge controller question, other...
  31. Banding Rotors
  32. MOVED: Charge Controller and Voltage Regulator
  33. Hello its the Mid-East Student
  34. windings ??
  35. unsure about stalling
  36. magnetic flux lines
  37. AC is really DC
  38. Using Furling Control on a Constant Speed Turbine
  39. Returned but not new
  40. Coil size question
  41. Charging schemes
  42. Anyone know why fieldlines has a hardcoded IP 69.175.14.182
  43. multiple turbines large area..
  44. jerry rigged clarification
  45. Not getting enough voltage
  46. Scrutiny of System Requirement calculations please
  47. understanding furling
  48. why three phase ?
  49. Combining turbine output
  50. Finding Reply's