Coil winding / Re: How to determine the limits of a coil / magnet configuration
« Last post by brandnewb on April 21, 2024, 08:10:45 AM »Which his good and important!!
I am less so thrilled about amonsts other my dear brother ED. And Joe.
Look brothers. I will understand that you have more important things to do than to educate a lost sole like my self.
But when inserting information / ideas and then to not follow up on the to be expected followups that then becomes in my books a bit less about helping and a little more about unintened confusion that might follow.
Anyways I was refering to the authors of the books / projects. You all know who I am talking about I just donit have it on hand right now.
The point I made earlier is that I bought both books of. yes finally I remember while typing. Mr Piggot. And I bought all magnets as suggested based on a design by the other 'prophet'
@magnetjuice, I think for now the focus should not be on your involvement as I am still figuring out on how to quantify.
Anyway there I went buying books either paperback or e-form.
This was me signaling to the ones helping/ (or al least signaling to me that I am bonkers and here you can get your head checked) me that I am willing to take drastic measures and leave no stone unturned.
My findings (with my limited reading capabilities) that any of those sources do not explain well how to use the findings in those resources to be of benefit to what it is I am trying to do.
And then the discussion died out pretty quicly as it seems the ones promoting said material also did not know how to deal with that one.
Sure I have been advised here before that Mr Piggot is open to concrete questions but for the life of me I dare not even start asking him as I do not even know how to properly condense these years of efforts I have under my belt.
Now by the tone of your question to me it still makes me think that I am more of a nuance than of a potential benefit. I am so sorry I come accros like that to some.
But in the end of the day I will go and do what needs to be done my dear brother. I hope you can help me out. Actually without your help and of other great minds this project is going to take much more time and perhaps even end up doing the opposite as it is inteded to.
You see if I build my premises and conclusions an based on bad understanding because I have not been challenged by the people in the know while I was forming ideas and plans.
Then my results, that I believe are trustworthy. Might actually serve as a base line for new generations while the results were never sound to begin with.
The moral of this all is that I still think I should just keep experimenting. Like just throw stuff on the wall and see what sticks kind of method.
The big difference with some charlatans is that I will fully show what never even reached the wall as well as what does stick.
My reputation depends on honesty.
{1}
hahha actually NO. I will not show anything that does not stick or not even reaches the wall. That is just too much of a burden.
the amount of tests I have run, some of them complete bonkers. is well..... bonkers
But I guess you have gotten the jist yes?
{/1}
EDIT: please never mistake me again for someone that just rambles for the rambling only.
Sure I invented rambling but I always have my ethics to back it up when challenged.
So here you go.