View full version: Wind
  1. New Project Newbie
  2. Gas powered AIR-X
  3. Not Home built but this is my new turbine.
  4. Dans 17'
  5. Question about small magnets.
  6. New VAWT
  7. Calculating ZubWoofers
  8. Chinese manufactured blades
  9. Ebay Small Wind system
  10. Other Power wind parts specs.
  11. Wind installs pass 10,000 Megawatts
  12. Triple Rotor / Double Stator?
  13. First wind turbine: I need a bit of advice
  14. A question for DanB
  15. Coils
  16. is this motor worth converting 25hp dayton
  17. new to wind energy
  18. Trying to find what my vawt is doing
  19. Reducing wear on wind generator
  20. Chinese VAWT's
  21. Measuring power output
  22. Coils - Wound w/out Splices
  23. Vertical Axis Design - your opinions?
  24. composite blades, used in water?
  25. Data logger
  26. axial flux applications
  27. would like 75W (12V) @ 11MPH, is that ok/possible?
  28. DanB's 17ft Machine
  29. windmill noise
  30. Windmill design for a 20-30 HP 3 Phase Motor
  31. Tape drive motor
  32. Lenz Turbine
  33. Volts per Coil
  34. Laminating wood
  35. Efficiency
  36. A question for DanB
  37. 12v vacume motors for wind generators?
  38. I'm test flying
  39. Vail Resorts to use wind power
  40. Maybe a Conversion
  41. Question about rotor?
  42. Doubling wire question
  43. Sanity check on load balancing..
  44. Dead ametek?
  45. Piggots 2 foot radius prop blades
  46. BIG Wind generator start
  47. Fisher & Paykel
  48. Wind turbines in freezing weather
  49. Ametek motor magnets
  50. Is This Charge Controller Any Good?