View full version: Wind
  1. Another idea for casting magnet rotors
  2. To the newbie's - part two
  3. Looking for some confirmation on research
  4. To the newbie's
  5. finished 1hpdc
  6. Rookie Mistake
  7. Pot the rotors or not
  8. 3 hp motor conversion
  9. How big do my magnets need to be?
  10. I don't mean to act thick
  11. Downwind turbine - advantage/disadvantage?
  12. these blades good?
  13. magnito from lawn mower
  14. Large one blade prop, am i nuts to consider it?
  15. #15 coil, 100 turns, size?
  16. Lattice tower plan question
  17. Tower Height Versus Swept Area
  18. dakota mill
  19. Pivot bearings?
  20. Fantastic Motor Building Site
  21. advice on conversion
  22. Confused about blade design?¿?
  23. Furling confusion
  24. Laminated blade material
  25. 16 ft. blades...
  26. Installing a Rohn wind turbine tower
  27. What will this DC motor output?
  28. balancing weight position?
  29. New disks? Minimum Thickness?
  30. #24 guage wire for coils
  31. CNC Blade Carver - Part #2
  32. Crazy waveforms and poor performance maybe
  33. Put rectifier on tower or at batteries - impact on braking?
  34. furling question
  35. Cordless Rotary kettle - slip rings?
  36. VAWT Rotation Direction Question
  37. blade balancing
  38. meter readings
  39. VCR parts work for small VAWT?
  40. Efficiency of Windmills
  41. 3 hp motor conversion
  42. Need some advice for using 2x2x1 magnets...
  43. New 11 feet Blades.
  44. Question on Rooftop windmills
  45. 1 1/2 HP motor conversion
  46. windy boys
  47. MAKE Magazine Article Help With Motor Selection
  48. Interested in 4.5 to 6 MW mill?
  49. CNC Blade Carver (Part #1)
  50. Questions regarding a PM motors