Attachments: inside spinner.JPG inside spinner.JPG
Attachments: PXL_20240522_001456763.jpg PXL_20240522_001456763.jpg
Big issue in my city everywhere... Mary got it right, spikes are the only viable solution.
... Or a rifle
Big issue in my city everywhere... Mary got it right, spikes are the only viable solution.
... Or a rifle
Attachments: tormus.jpg tormus.jpg tower5.jpg tower5.jpg
Attachments: voor- en aaz.jpg voor- en aaz.jpg
(Attachment Link)
9 coils / 12 magnets.
According to the Bavaria Winding Diagram Table, 9 coils / 10 magnets would be a better combination.
Attachments: onderdelen.jpg onderdelen.jpg
Attachments: 1 m bladen.JPG 1 m bladen.JPG
Attachments: blad vb..JPG blad vb..JPG
Attachments: spinner..JPG spinner..JPG
Attachments: spinner.JPG spinner.JPG
Attachments: aandrijving.JPG aandrijving.JPG
Here is why I needed to overhaul the Azimuth drive to begin with.
Need to revers engineer the circuit, easy enough to repair as just the rectifier module that blew but over all circuit is functional still.
(Attachment Link)
(Attachment Link)
(Attachment Link)
Now I will stop rambling now again for a while as I am still not even sure if this will even get out thereIt absolutely will, your posts increased in quality by several orders of magnitude, I am very glad to see that once you're calm and collected you're not rambling all the time and posting 7 times in a row, you're actually writing properly with some good points! Carry on like this
Attachments: main axle.JPG main axle.JPG
Reminds me of the satellite television dish my parents had when I was young. It used pivots to tilt back and forth. The pivoting apparatus bore its weight on an arc shaped bar. As you rotated the dish horizontally there were wheels that rested against the bar. The bar sat on the horizontal pivot before the dish tilt machinism and could be adjusted about to any direction before keybolts held it tight against the main horizontal pivot. Until wind got in the low 50s the big dish could hold a tight signal.
Attachments: nacelle.JPG nacelle.JPG
Do image system work now ?Yes, been a while https://www.fieldlines.com/index.php/topic,150905.0.html
That's a facebook link and they got temporary signatures to show up, since Meta don't want us to use 1mb of their bandwidth and can't afford servers the image signature is scrambled every so often so people can't hotlink images off there.
@topspeed please put the actual images and don't hotlink off facebook image links, as it will only work for a couple of hours and then break itself, sadly not something I can do anything about You can rest assured that if you upload the images on our forum they won't go away instead (unless the server and the backups implode but we don't talk about that ).
Attachments: statief.JPG statief.JPG
Attachments: 18 rpm. 4 V.JPG 18 rpm. 4 V.JPG
Thanks for this wonderful piece of information. I been reading all your post for years.
Wondering the dimensions of your Heatsink or where to buy .
Now working on a triac based 3 stages Charging system and Transfer system.
Thanks in advance