Homebrewed Electricity => Wind => Topic started by: deerslayer660 on September 05, 2004, 07:49:57 AM
Title: ecm motor mill up
Post by: deerslayer660 on September 05, 2004, 07:49:57 AM
this is the 1 hp ecm i posted a few months back for sale since no one was interested i decided to go ahead and fly it and don't you know it no wind not even a slight brezz i hope some of the huricane wind makes it to ohio! any way the 1 hp
ecm made 140 watts into a half charged car battery with a cordless drill the three
windings are each rectified seppertly at batterys than outputs are parraled with a
22000 uf cap a mikes bioelectifer charge controller useing 2 hallogin car head light bulbs as a dumb load ( mike if your reading this and i know you probley dont want
bothered please let us know your ok we love ya man ) i still have the 12 hp ecm
and will sell it to the highest bidder i'm not trying to get rich i just know how hard these are to get a hold of and highest bid is the only fair way i know to let some
one here get it i'm in the hvac biz and my suppler saves the warrenty returns for me
only have got these two in 2 years. i have to buy him lunch for each but i guess
that this is not to bad since i have never had to change one myself brain was bad
on bolth but motor and bearings are like brand new i guess time will tell how well they fly george
Title: Re: ecm motor mill up
Post by: deerslayer660 on September 05, 2004, 07:56:18 AM
schould have read i still have the 12 hp ecm for sale
also why do i have to make a secound post to put in my pics if i start a new post there is only a place on bottom of page for a poll not a place to insert pics till
i post a comment? george
Title: Re: ecm motor mill up
Post by: deerslayer660 on September 05, 2004, 07:58:35 AM
that is one half hp not 12 hp cant put in the slash for some reason george
Title: Re: ecm motor mill up
Post by: TomW on September 05, 2004, 08:20:11 AM
deerslayer;
Sometimes the insert photo thing is on the right hand side of the page.
T
Title: Re: ecm motor mill up
Post by: kurt on September 05, 2004, 09:56:43 AM
1/2 1/2 1/2 hmmmm
/me shrugs
Title: Re: ecm motor mill up
Post by: deerslayer660 on September 05, 2004, 11:16:54 AM
i'm going to try again the one half thing = 1/2 1/2 it shows correct here
befor i post we will see also here is a pic of controlls by batterys george