Coil winding / Re: How to determine the limits of a coil / magnet configuration
« Last post by JW on April 19, 2024, 10:27:40 PM »carry on.
Thw waterwheel in this video looks like yours.
https://www.youtube.com/watch?v=lCNcwsglZP8
Brandnewb, do not tease us lol
No really Brother. I need to know what you actually meant to convey!!
Brandnewb, do not tease us lol
Attachments: base line measurements.png base line measurements.png
Attachments: Screenshot_20240407-152259.png Screenshot_20240407-152259.png Screenshot_20240408-045040.png Screenshot_20240408-045040.png Screenshot_20240408-171428.png Screenshot_20240408-171428.png Screenshot_20240409-171528.png Screenshot_20240409-171528.png Screenshot_20240410-051302.png Screenshot_20240410-051302.png Screenshot_20240410-182554.png Screenshot_20240410-182554.png Screenshot_20240411-174344.png Screenshot_20240411-174344.png
Attachments: fieldlines logo.png fieldlines logo.png
I wish you could post pictures of your setup. It's always neat to see what other off gridders have come up with for solutions.
wow, please allow me to be soo ignorant/blunt and yet soo intrigued.
please get me up to speed? top speed even if you will
I would like to learn more af what it is you are talking about here.
{1}So are you somehow showing evidence of what my gut has been telling me that this omnicalulator is not entirely accurate?
My lord do I want to get to the bottom of this {/1}
{2}when i search for The Idaho Black Hawk tilt rotor. I get cool yet non related stuff
same goes for ANEW in Poland
yes Single Wing Energy oy I can find. yet now I have to plow through. hmm I really do not want to do that yet.
I am here to help and learn not to start a new study
Can you please help me get going?
{/2}
There are 2 hots and a neutral feeding the breaker panel box which come out the wall where I had an old generator feeding power.. Those are the wires I need to somehow connect both generators to and be able to switch ti either the 240v or 120v generator.Any switch sold as a transfer switch could certainly be hooked on these wires and do what you are thinking. I think your plan for the welder cord makes sense too.
Hey, I am trying to hook up a 240v generator and a 120V generator to power a breaker panel box which will then send the power to the house. I want to be able to use a switch to decide which generator I am going to use. I wish I could upload a picture so I can show what I am trying to do, it would be much easier to understand.
I have been attempting to optimize the amount of voltage that can be generated from a CD Wind Turbine with a Lasko 20-inch 3-Speed Box Fan to spin the blades on all three speed settings. The blades that I am currently using are 13.5 cm long, and 4 cm at the base and 2.5 cm at the tip, with a very small curve (around 1-5 degrees). So far, I have managed to generate the greatest amount of voltage (around 2.5 volts) with a two blade setup.
From here, is there anything I could do to improve the design of the airfoil to generate more voltage? I know that longer blades tend to perform better than shorter ones (I'm planning to increase the length of the blades to around 17.5 cm for the next design), but how should I change the width and/or the curve of the blade for better performance on all three voltages?