« previous next »
Pages: [1]   Go Down

Author Topic: Garbogen pix sires #5.  (Read 867 times)

0 Members and 1 Guest are viewing this topic.

Jerry

  • Hero Member
  • *****
  • Posts: 1519
Garbogen pix sires #5.
« on: January 18, 2007, 05:18:11 AM »
This one was an expiriment that worked very well but was expencive. My new yaw system is very simular but lighter and cheaper. The thick plexi was left over from a show car we did.





Alt in cradel.


                       JK TAS Jerry

« Last Edit: January 18, 2007, 05:18:11 AM by (unknown) »
Logged

willib

  • SuperHero Member
  • ******
  • Posts: 2414
  • Country: us
Re: Garbogen pix sires #5.
« Reply #1 on: January 17, 2007, 11:00:47 PM »
Hi Jerry ,interresting stuff

what is the outside dia of that garbogen?
« Last Edit: January 17, 2007, 11:00:47 PM by willib »
Logged
Carpe Ventum (Seize the Wind)

Jerry

  • Hero Member
  • *****
  • Posts: 1519
Re: Garbogen pix sires #5.
« Reply #2 on: January 17, 2007, 11:13:11 PM »
Hi Willib.


The outside diameter is 6.25". I use the 6" mufler clamps from NAPA as the cradel.


I open them up a littel on a 6" grinder wheel. The 5.5" mufler clamps fits the furnace blower motor perfectly. BTW the stator bore on the Garbogen is 3&5/8"s.


                         JK TAS Jerry

« Last Edit: January 17, 2007, 11:13:11 PM by Jerry »
Logged

willib

  • SuperHero Member
  • ******
  • Posts: 2414
  • Country: us
Re: Garbogen pix sires #5.
« Reply #3 on: January 17, 2007, 11:34:13 PM »
Very slick looking , thanks

ps i really like the plexi-glass
« Last Edit: January 17, 2007, 11:34:13 PM by willib »
Logged
Carpe Ventum (Seize the Wind)
Pages: [1]   Go Up
« previous next »