Author Topic: Mods to hot water cylinder - links wanted please  (Read 2031 times)

0 Members and 1 Guest are viewing this topic.

sunandwindy

  • Newbie
  • *
  • Posts: 7
  • Country: gb
    • www.sunandwindy.bitz.me.uk
Mods to hot water cylinder - links wanted please
« on: March 15, 2013, 07:54:16 AM »
I'm struggling to find any suppliers of bits for hot water cylinders, so perhaps my terminology doesn't help.

I'm looking for a 28mm indirect coil to retro-fit inside a copper hot water cylinder. Is there a special name for this item and who sells them please?

Also... I know there is a special name for this item, but I can't remember what it is :( I want to add a second immersion heater flange, I think these come as a solder fitting and a split flat that sort of folds up to get one part through the hole. Again I need the proper name and a potential supplier please?

Thanks for any help given :)
Based in the UK near Gloucester/Herefordshire boarders

DamonHD

  • Administrator
  • SuperHero Member
  • *****
  • Posts: 3622
  • Country: gb
    • Earth Notes
Re: Mods to hot water cylinder - links wanted please
« Reply #1 on: March 15, 2013, 09:07:39 AM »
Just in case no one can help you here, maybe go and ask on ebuild.co.uk where there are likely several people who know the magic UK names!

Rgds

Damon

sunandwindy

  • Newbie
  • *
  • Posts: 7
  • Country: gb
    • www.sunandwindy.bitz.me.uk
Re: Mods to hot water cylinder - links wanted please
« Reply #2 on: March 17, 2013, 06:10:45 AM »
Apparently 'sidewinder' is one name used... I'll keep looking
Based in the UK near Gloucester/Herefordshire boarders