« previous next »
Pages: [1]   Go Down

Author Topic: poured single phase stator  (Read 1475 times)

0 Members and 1 Guest are viewing this topic.

(unknown)

  • Guest
poured single phase stator
« on: November 29, 2008, 02:05:41 AM »
The plan is to have a total of three small single phase permanent magnet alternators. The reason is because of the fabrication technique used.  I am using a 6"to 4" pvc converter as a housing.  Future photos will illustrate.  I cut off a 1/4 inch of the 6inch converter to use as a mold on a gannet tile. I applied Vaseline to the mold and tile to prevent the resin from adhering or running out of the mold. Two more to go.      



« Last Edit: November 29, 2008, 02:05:41 AM by (unknown) »
Logged

electrondady1

  • SuperHero Member
  • ******
  • Posts: 3122
  • Country: ca
Re: poured single phase stator
« Reply #1 on: November 28, 2008, 08:31:03 PM »
good to see your progress
 i have been following your posts .
i very much like your alternator design
it appears to be waterproof
good luck with adding more phases.
« Last Edit: November 28, 2008, 08:31:03 PM by electrondady1 »
Logged
Pages: [1]   Go Up
« previous next »