Thanks for the replies!
Even the ones that sounded like they are talking to school kids.
~
(I did build and have a liquid cooled, UV reactive, TEC boosted Video card blocks, home made RAM water blocks, PSU home-made water cooling blocks with phase change assist "LAN/Gaming computer")
Phssthpok-
Thanks, I was wondering about oil's but didn't think they would work as well as water does.
electrondady1-
Thats what I was looking for, Idea's and thoughts on places to get the pricey stuff cheaper!
Now wondering about "Lube Shops", they also change other fluids and might have a barrel or two waiting for the Haz mat truck to come by and charge them to remove it?
I'll stop by a few body-shops also as they are still friends for my paint store owner days. LOL.
Drain-back, is part of the plan but the whole shed/shop still isn't getting any warmer than outside air or just a bit more from no wind-chill.
Unless I'm there running heaters trying to finish floor so I can get back to the re-insulationing with New good stuff!
ceiling and walls still stripped bare of old nasty insulation that was in there for years.
I'm just thinking ahead and putting in the stuff I'll want down the road, plex water hoses in the floor, many, many wire runs and hose runs for future uses.
Eddy current was a new plan from re-searching around this site. Only testing so far was a little 3" steel rotor with 6 magnets in cordless drill holding a 1/8" copper tube between it and a steel part. It did get warmer after awhile.
This will need a real set of rotors turning to test a copper tube type stator. "Down the road"
LOL
L8R