Hi all.....new user here, this site is great....I see many uses of wind turbines, etc....everyone one this site is so intelligent which is super..this is why I am happy to be part of it......I have had a Air 403 wind turbine sitting in my basement for a few years along with a Trace sw2512 sine inverter and 8 deep cycle batteries, sub panel and everything necessary to install alternate energy....I do tinker with electric around the house, but not with panels, etc.....I had a few electrical contractors here but had to get rid of them for one reason or another....for "being way overpriced to do the job".....one actually came and installed the inverter on the basement wall with the sub-panel next to it and pvc to the main panel box.....it seemed to be going well...then he just never showed up again....never hooked up the turbine wires to the batteries.....maybe did not understand standard battery hook-ups or what.....but I would not been able to trust what he had done anyway....the wires he was about to install from the main panel thru pvc to the sub-panel were no larger than wire running a toy car.....I pulled them out right away....I new just in tinkering with installing electric in my home that was not correct....one guy was a electrical teacher at a trade school..he was a disappointment, after looking at everything he suggested that we build a model of this first....out the door he went....so on and on and on until I happened to see this site...it's great.....so if there is a person reading my post and has a similar setup "BOY" would you be so kind as to show me on paper just what I would have to do in Layman terms....not schematic terms on how to install all of this mess....I would post for you everything I purchased to finally put my project