I am now days working on the same project, to lift water upto 200 ft head ,
I am using APC-UPS 2200W, SINE WAVE, CONNECTD DIRECTLY WITH UPS no batteries,and a submercible pump of 1 hp connected with UPS.
This UPS is 48 volt in DC, SO I arrange solar pannal 4x80 w 12 volt 4.5 Amp pannel in
series, two set so volt same, ampare doubles. 9 amp.
when I started UP, it started working with 220 volt ac, I connected pump, the
UPS switch off. did run pump.
I revised the exercise with 4 batteries in series, and them connectd with UPS.
I started UPS on AC, 220 volt, then I connected pump, it start running,
I swtich off AC, the UPS run on battery, and pump didnt stop,
I checked following noting
when running on 220 volt AC pump show 5amp load
when running on batteries dc pump show 15 amp load,
so what I concluded, that I have to increase no of solar pannal upto 15 or above
15amp, to run pump directly with solar panals, via UPS.
as soon as this all complete I will again post all the details in this forum,
with photo graph,
If some one did this exercise before, they send their comments
Shah Kamal
Pakistan