to finnish of my 2 phase alternater made from single phase motor I need to heat sink my rectifiers an wonder what everyone else does for this.Thought about just bolting them onto main frame just behind genny but dont know if this will cool them well or do i need to go to ally heat sink of somekind.I don't expect much above 16 amps total output and are using 32 amp recifiers.On my tape drive mill I have put diode right next to 12volt battery bank,but need to rectifie this one on or very near genny as I have about 30 meters of wire from mill to batt bank and the wire is to expensive to run 4 wires.
Thanks in advance,regards,
Mos