MC4 connectors needed

[dnix71]

I need 2 pair so I can make a proper cable for a pair of panels I bought. I also need a handfull of 60v 4 amp Schottkies. That's a bit higher voltage and amperage than the cheap Schottkies on eBay. Does anyone here on the forum sell these? I have paypal and personal check, your preference.

[TomW]

I have 2 pairs ie 2 of each male and female I cut off my Kyocera  panels. They have at least a couple inches of wire on each. Certainly enough to get a good connection to the conductors.



They are yours if you want them.

Can't help on the other stuff.

Just PM me with where to send them.

Tom

[ghurd]

I have 60V Schottkys, but they are 10A.   
TO-220, and really should have a heat sink.
G-

[rossw]

I also need a handfull of 60v 4 amp Schottkies. That's a bit higher voltage and amperage than the cheap Schottkies on eBay.

I needed some, I researched a little bit and found TO-220C case, 16A 150V schottky from radiospares of all places, $1.26 australian each in packs of 5. I got two packs (I needed 6) and ordering off the website it was free freight.

Here is a link to them

They also have 150V/20A, and 200V and lots of others at varying prices.

[dnix71]

I'm getting the mc4 conectors from TomW and the schottlies from GHurd. Thanks guys.

[TomW]

OK, solutions achieved.

Thread closed.

Tom