I spoke to Todd at hurricane.
He told me I could have him mail my experimental PMA to me or that he could hand deliver it around the 23rd to the 25th of May.
I asked what the cut in was with a resistance load of 12 volts… He said that he does not have those numbers yet because he has been busy building it… He said it does produce 12 volt at 100RPM with no resistance. And that it creates an impressive electric arc at 150RPM which is a good sign of amps.
I pressed him for chart data and he confessed to me that Charts are not a good subject with him, because on all his old units he hired an engineer to draw up charts and the man took advantage of him by giving him bogus charts. He said that this new design has spawned 4 new designs and that he intends on creating entirely new accurate charts to reflect all his new PMA's abilities…
I told him once that is done he should go back and also make new charts on the old designs too and that his old charts where a
big problem for the folks on this forum and made his reputation look pretty bad to them.
He agreed and said that now he knows far more now, then he did back then and that he will not allow himself to be taken advantage of again, by poor farmed out work from labor or lazy engineer's who generated crap numbers just to get him tio cut them a check.
Todd has to wait another week on the magnet company here in the Raleigh area to cough up an appointment for their nickel tour of their super secret plant. Since he had to wait that extra week vbefore he could get down here, I challenged him to take that extra week to come up with a performance chart on the new PMA with it under a 12 volt resistance.
He said he would do that…
It looks to me like Todd is trying to turn things around in a BIG way...
And that is my PMA update for this week…