Generator mount side plates are cut from 3/8" plate. Again these fit over the cantilever pipe and are welded in place. Tomorrow I will cut the generator mount 1/2" plate top piece, and the slide plate that sits above the top piece of the generator mount. This slide plate will allow tensioning of the belts.
Other bits, pieces, and big chunks will arrive over the next week or so. Pretty soon the final welding takes place! I need to mock up a stand on dry land as well to spin the wheel on the cantilever to make sure everything works and the belts are aligned and tensionable.
I also note as I attach this picture that since I have over 50 posts my pictures can be much larger in KB, so future pictures will have more detail.