Question or you guys... So, 2 of the 3 boards were without warp. I leveled the root and checked the level at each station. Now, the third board, after I leveled the root the tailing edge is higher than the leading edge. The opposite, Hugh Pigott says to take the measurements with the help of the level raising it. My question, since the leading edge is lower than the trailing edge can I shave down the tailing edge with a plane to make it level before I take my drop measurements? Or, must I lower the level to compensate for the warp?
***Edit***
Or, does it mater as long as I do the same to each?