It should be ok but the voltage is a bit low if you are thinking of a 48v system.
Unless you have a manufacturers brand device you just have to assume it will do the job, but don't push it too hard. Even with full spec devices from IR or General Semiconductor these things will not handle 35A except into a resistive or inductive load and even they need an almost infinite heat sink. With capacitive or rectifier loads there is a further de rating.
Under typical conditions with reasonable heat sinks I would imagine it would be happy at about 15A. Their rating is for single phase and with wind power the rating is not a lot more for 3 phase so about 20Adc I would say is a realistic limit.
Although convenient I personally never use them except for small machines. If you need to parallel lots of them there is even more of a de rating and you are better off with stud diodes even though they are not so easy to mount.
Flux