I just purhased a Doc Wattson meter and need to verify just how to hook it up. I've done all the pelimary research by searching this site for info and going through the RC Electronics web site too. OK so do I hook the black 'source' wire to the negative side of the rectifier and the red 'source' wire to the positive side of the rectifier then the black 'load' wire to the negative side of the battery? I'm sorry if this seams like a stupid question but I just want to be sure. Any advice will be greatly appriciated. I just want to use this meter to measure the output (amps, amp hours, watts etc.) of my 10' wind turbine.
Thanks,
Tink