« previous next »
Pages: [1]   Go Down

Author Topic: The 8 Inch Rotors with the 5 foot TLG blades  (Read 1039 times)

0 Members and 1 Guest are viewing this topic.

(unknown)

  • Guest
The 8 Inch Rotors with the 5 foot TLG blades
« on: May 27, 2007, 09:06:16 PM »
I have everything assembled on the axle stub. These are the 5 foot TLG aluminum blades. Going to wind a test coil later this week and do some testing. 1x1x.5 inch N42 magnets, 12 per rotor. I have the gap set at 9/16ths of an inch.
« Last Edit: May 27, 2007, 09:06:16 PM by (unknown) »
Logged

Mary B

  • SuperHero Member
  • ******
  • Posts: 3205
might help to post the picture!
« Reply #1 on: May 27, 2007, 03:10:39 PM »
Might help to post the picture!
« Last Edit: May 27, 2007, 03:10:39 PM by MaryAlana »
Logged

Flux

  • Super Hero Member Plus
  • *******
  • Posts: 6275
Re: might help to post the picture!
« Reply #2 on: May 28, 2007, 02:34:44 AM »
Looks nice so far. Have you chrome plated the discs or something, they look very shiny.


Flux

« Last Edit: May 28, 2007, 02:34:44 AM by Flux »
Logged

Mary B

  • SuperHero Member
  • ******
  • Posts: 3205
Re: might help to post the picture!
« Reply #3 on: May 28, 2007, 09:06:04 AM »
No, that must have been a trick of the lighting. Thinking of priming them and then a couple coats of epoxy paint instead of casting them.
« Last Edit: May 28, 2007, 09:06:04 AM by MaryAlana »
Logged
Pages: [1]   Go Up
« previous next »