[Covered in depth recently user obviously did no research bye]
I'm planning a windmill but i do not want to use it for charging batteries but to power heating element to heat water.
I like to use regular heating element 120v or 240v. Is it possible to built something like this from scrach with PMG???
What design should I choose 2 stator/1 rotor or 2 rotor/1 stator???
I plan to use it as a pre-heat for floor heating. The water in the floor is at 95F° and I took around 4° delta to heat my shop. I'm using a small water heater(6gal.) with 4500W element to do the job right now.
Will I need some special control devise or just use 3 heating element the same wattage(3phase) will do the job???
Will I end it up with an overheating stator if I try to do a 120Vac or 240Vac wind mill???
Any of you guys built something like this?
A lot more question is comming to my mind right now but let see what you guys think about the project.
Thanks for your help
Max