« previous next »
Pages: [1]   Go Down

Author Topic: -Treadmill motor  (Read 1134 times)

0 Members and 1 Guest are viewing this topic.

Jason Wilkinson

  • Full Member
  • ***
  • Posts: 181
  • Country: bb
-Treadmill motor
« on: January 13, 2010, 06:09:43 AM »
Greetings for 2010 to all, I was given a treadmill motor

 Permanent Magnet DC Motor:

CW rotation:   electrical rating @ 240 vdc :    FF  1.0  :  2.0 HP: 5250 rpm : 8.5 amps.  Spinning by hand i can get 12 volts , turning it at 60rpm   ie 1 rev/sec. i get around 2.0 to 2.3 volts  the motor vibrates as it turn (cogging i suppose) and not as smooth as the axial flux. Any chance of making good use of it ?

 Jason

 
« Last Edit: January 13, 2010, 06:09:43 AM by (unknown) »
Logged

ghurd

  • Super Hero Member Plus
  • *******
  • Posts: 8059
Re: -Treadmill motor
« Reply #1 on: January 13, 2010, 08:33:16 AM »
That is a pretty good one.

G-

« Last Edit: January 13, 2010, 08:33:16 AM by ghurd »
Logged
www.ghurd.info<<<-----Information on my Controller

Jason Wilkinson

  • Full Member
  • ***
  • Posts: 181
  • Country: bb
Re: -Treadmill motor
« Reply #2 on: January 14, 2010, 05:02:12 AM »
Many thanks ghurd,will carve a set of 3ft blades and see if it will light a 12v car bulb

 Jason
« Last Edit: January 14, 2010, 05:02:12 AM by Jason Wilkinson »
Logged
Pages: [1]   Go Up
« previous next »