hello all
this is fanman back again, ive been off the net for a few months during my relocation, now im ready to hit the wind power again, anyway i built a axial flux machine a winter ago, with the idea of no bateries, only to heat with it, and the controller was my next step, now i see that were trying capacitors in line with the heaters to make the gen start up easier, thats a great idea, but how exactly does it hook up? i have a 120 volt three phase axial flux capable of 5kw, 16ft blades, i run three wires down my tower to a three phase bridge rectifier, then to three 120 volt water heating elements, some of your sites say to hook caps up in series with the heater, could someone make me a schematic of this, i would very much appreciate it,