View full version: Wind
  1. PM Gen finally Done!!!
  2. Homemade wind tunnel...
  3. Wind is right.
  4. wind flex on bigger props help
  5. Lenz2 test machine complete
  6. Measuring Force to start Fisher & Paykel Alternator
  7. clockwise in northern hemisphere.
  8. Anchors a Weigh - Gin pole / anchors photo
  9. MY FIRST CONVERSION
  10. Monday Oct 3
  11. Diversion loads for Wind turbine
  12. Alternator Efficiency
  13. Airfoil-missing losses
  14. circut for my lighthouse
  15. magnet questions
  16. 12 volt and 48 volt stator?
  17. torque calculation
  18. Rocky Mountain Sustainable Living Fair
  19. Versatile experimental windmill
  20. how would you modify the stator design to allow faster speeds?
  21. Mounting Rotor on Chimney stack.
  22. Anyone familiar with this tail design?
  23. My version of the Wood AX...the beginning
  24. Well , my Lakota is up
  25. First strong wind on my wind Genny, terrifying moment but everythings OK
  26. child of 12 built wood ax /103
  27. Possible problem of flow with rotors in steel inox?
  28. AS I CAN RECOVER THE MAGNETS RESINED IN THE ROTOR?
  29. Glueing/Laminating fir for "prop" (rotor)
  30. Getting the most out of multiphase
  31. A few thoughts from a trained engineer but a wind turbine Newbie
  32. How to measure the power output of a PMA?
  33. Find of the day
  34. made some blades today
  35. Windmill; 150' between windmill and Batteries
  36. Blade Parasitic Drag On Vertical Axis/Horizontal Axis
  37. a fresh start
  38. Finally finish my first genny !
  39. What servo motor to use???
  40. 48v gen update
  41. Lenz turbine question
  42. Any REAL large wind genny plans out there?
  43. Tommorow is the last day of a long travel in wind generation
  44. My attempt at an eight foot wind generator.
  45. new 8 magnet, 6 coil generator
  46. Wind genny out at sea
  47. First Test run on 8 foot genny.
  48. Twin Stepper Gens Up...
  49. Axial Flux Finally
  50. "Test Tower" Finally Completed